Long Island Shooters Forum banner

Sling Stud Install Questions?

743 Views 2 Replies 3 Participants Last post by  Bottomrock
Figuring it is about time that I install my sling studs onto my Ruger 10/22. I just have a quick question about the placement of the studs. I have searched a little bit, and haven't really found a set standard answer. Does it really matter where you place them? Is there recomended distances from the Butt, and from the foreend that you should place these at? My stock is composite, so should I put a little epoxy in the holes I drill when I screw the studs in?
1 - 3 of 3 Posts
1 1/2 from the end of stock & yes use epoxy & the front stud goes in between the front barrel band slight filing maybe needed no epoxy or loctite needed
U can also choose to use the machine screw with nut for the front stud. Drill a little recess inside under where the barell sits.  Nut is tightened into that area. Yes epoxy for the butt end if using this method.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.