Long Island Shooters Forum banner

pushing ak barrel out of whole receiver

962 Views 1 Reply 1 Participant Last post by  m1lk
this one was tough, but budged thanks to pblaster.

5/8 socket - fulcrum base
short socket extension - fulcrum
11mm socket - pusher
pennies - protect barrel
akbuilder bucking bars - lever
bucking bar screws
homemade barrel assembly jig
short bucking bar - press head extension

sgl parts were immovable from gunk and carbon crap. pblaster soak for 24 hrs at least for those stubborn barrels.

arrange as shown. 11mm socket square end up. screw in nut on bucking bar screw a little and put in 11m socket. akbuilder bucking bar should fit snug between all that crap and extractor hook rail.
1 - 2 of 2 Posts
wjoops. 3rd pic supposed to me this:
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.