Long Island Shooters Forum banner
1 - 7 of 7 Posts

· Member of the secret Canadian Mafia
5,770 Posts
Discussion Starter · #1 ·
Okay, all these posts with newly made knives has my juices flowing....

Can anyone recommend a good (cheap?) beginner belt sander for knife making?
  • Like
Reactions: Ekim and mattyj513

· Registered
900 Posts
I am using a craftsman 2x42, That was basically pulled out of the trash can't get any cheaper than that. Its a good machine, but Ive never used a $2000 grinder so I have no comparison
+1 best bang for the buck in beginner grinders. Its what I started on. Just make sure to get a glass platten for it. Usaknifemaker.com has them for about $12.
Next best thing after that is a Grizzly 2x72 but its around $600 or so I believe.
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.