Long Island Shooters Forum banner
loading
1-14 of 14 Results
  1. AR - [Rifles]
    This is a probably a silly question, but I couldn't find any informative YouTube videos. How do you load the mags? It doesn't seem possible to load the bullets straight down like 5.56, and loading from the side like a pistol mag is really awkward. It took a few minutes just to get 7 rounds in -...
  2. Recalls
    "IMR Legendary Powders has issued a recall on six lots of 4007 SSC. These lots were sold in both 1-pound and 8-pound containers. If you have any IMR 4007 SSC check the label on the container immediately to determine if your powder is from the affected lots. Lot numbers affected by the recall...
  3. Pump [Shotguns]
    Pulled this of the MDTS FB page...using the Aridus QDC Side Saddle Shell Carrier
  4. DIY Projects and Builds
    Looking for some guidance from someone with experience on opening up the loading port on a semiauto shotgun. Trying to figure out where is best spot to remove the least metal. Nothing drastic, kind of like opening up and polishing the intake and exhaust ports on a small block Chevy.
  5. Reloading
    I'm always looking for things to make my reloading easier... Was in Costco today and found a set (3) of clip on My Lights. They are about 4-5 in and fully adjustable, run on 2 buttons batteries, with a nice c type clip on one end. Set came with spare set of batteries for each... $12. Run time...
  6. Other - [Handguns]
    Found this link at Sipsey Street Irregulars. http://www.mediafire.com/view/8ddbm8v1fxb3899 http://sipseystreetirregulars.blogspot.com/2014/07/praxis-diy-sheet-metal-self-loading.html
  7. Reloading
    I have looked at several different sets from RCBS, redding, lee etc. I have checked out the gold medal series from RCBS & the national match series from redding & I don't know which of these offerings will be the best quality for loading heavy .223 ammo. I am obsessed with having the best tools...
  8. Reloading
    Friend of mine needs some blanks for his .38. I have the brass primed and ready to load. I will proberly use 5 to 6 grs of bullseye. What can I use to seal them. would wax or silicone or glue a cardboard cap in case.
  9. Chit-Chat
    Hi members, i just completed a build and am having 1 issue. When i load the rifle for the first time, insert the magazine, pull the charging handle, sometimes it will not feed the cartridge into the chamber. And sometimes when a round goes into the chamber, if i drop the magazine and pull the...
  10. Open Firearm Discussions
    The horror............
  11. Semi-Auto [Shotguns]
    Last time I was slug shooting with my Mossberg 930spx I was having some trouble loading the 6th round in the tube. This I know must have been because that is where the magazine extension meets with the fixed. I know this has been an issue for the spx and I checked the ext tube for burrs and...
  12. Revolvers [Handguns]
    Maybe this has been addressed already but I could not find and thus hope someone will be kind enough to supply with a knowledgeable answer: Does the NY SAFE Act require revolvers to be loaded with less than 7 rounds? I am pretty sure that requirement only applies to magazine fed semi-autos and...
  13. Reloading
    Looking to start reloading my self. Looking to start buying all the stuff piece by piece. I want to order a press this week. I was looking into the lee classic turret press. What are you guys using and what do you recommend. I will b reloading mostly hand gun rounds as well as some rifle...
1-14 of 14 Results
Top